Kaleidoscope Stencil Shaker Card

RSS
Kaleidoscope Stencil Shaker Card

Happy Tuesday Everyone! Brutus Monroe has come out with two new stencils this release, and today I'm using the Kaleidoscope stencil with a few other Brutus Monroe products to make a shaker card for Christmas.

I started with a piece of 6 x 6 cardstock and the Kaleidoscope stencil, I taped them both down to my media mat. I used the Brutus Monroe Honeysuckle Surface Ink and a finger dauber to pounced the ink all over the stencil until the entire cardstock was covered.

After I was done I stamped one of the snowmen from the Snow Friends stamp set and colored him with copics, cut him out and then prepared my shaker card.

For my shaker card I used some pink beads from stash and Brutus Monroe Bottle Cap sequins in Ballerina. 

I assembled my card using Brutus Monroe craft glue and foam tape and finished by cutting a banner for my sentiment. My sentiment, Merry Christmas, is from the Brutus Monroe Comfort and Joy Holiday Inspiration Box.

That's my card for today, I hope you enjoyed!

Lori

 

Below is a list of supplies used in today's card!

 

Previous Post Next Post

  • Lori Uren
Comments 0
Leave a comment
Your Name:*
Email Address:*
Message: *

Please note: comments must be approved before they are published.

* Required Fields