Ornament Stencil | Getting More Use From A Stencil

RSS
Hello everyone and Happy Tuesday!
I made another Christmas card this week using the Ornament Stencil!
I also used the Brother Scan n Cut!
I have a pic tutorial today.
First I used a piece of white Neenah 80 lb. cardstock, an ink pen, and the Ornament stencil.
  
I traced the stencil on to the cardstock and then ran it through the Brother Scan n Cut.
  
I used a rectangle die to cut it and placed it on my card base. Make sure to save this piece, it will go over the card base.
I traced the ornaments on my card base with a pencil.
After tracing just use your Brutus Monroe glue and place your sequins in the shaped ornaments. It really didn't take very long at all.
Before I placed my cut piece on top I used my Versamark pad and ink the entire panel and heat set it with Diamond embossing powder to give it more sparkle. I popped up my card with foam tape and placed it on my card and added a bow.
Here's another look at my card.
I love the way this card came together and I hope you will give it a try!
Shop Brutus Monroe and supplies I used for this card here:  
Thanks for stopping by,
Lori

Previous Post Next Post

  • Lori Uren
Comments 0
Leave a comment
Your Name:*
Email Address:*
Message: *

Please note: comments must be approved before they are published.

* Required Fields